Pre-Swaged kits come ready made to length (supplied by you at time of purchasing) with fittings Hydraulically Pressed (swaged) to the ends of the wire. Examples of the fittings that are hydraulically swaged are Fork Terminals
and Jaw/Swage Rigging Screws
.
These are the easiest kits to use and no special tools are required. When puchasing this type of kit we will require the inside to inside post measurements of your two end posts. You can still pass the wire through any centre post by drilling an 8mm hole.

Each wire has +- 30mm from the measurement provided. If your posts are not 100% vertical you should supply the average length for us to make the wires to.

You will also need to purchase the wire (3.2mm 1x19) to go with these kits as a separate item. To calculate the wire required multiply the quantity required by the length of the wire. Eg:
11 x 1554 = 17094
11 x 2459 = 27049
11 x 5654 = 62194
Total wire = 106 meters

You will also need to type the lengths and quantities required into the comments section during the checkout process.

Make sure you click on the product details link for each kit to find out more information about the kit.